Quick Answer: Modern gas furnaces use a hot surface igniter or spark igniter paired with a flame sensor, while older Mansfield furnaces may still use a standing pilot light and thermocouple. Call (419) 589-4315 to connect with a local technician for safe ignition repair.

What This Service Involves

Ignition repair covers testing and replacing brittle silicon nitride or silicon carbide hot surface igniters, cleaning or replacing oxidized flame sensors, calibrating spark ignition modules, and replacing worn thermocouples or pilot assemblies on legacy units.

Common Signs You Need Igniter & Pilot Repair

  • Draft inducer runs, you hear a click, but burners never light
  • Burners light brightly and then shut off within 3 to 8 seconds
  • Standing pilot light refuses to stay lit after releasing the reset button
  • Visible hairline crack or white scorch mark on the hot surface igniter
  • Control board flashes an ignition failure or flame-loss error code

How Our Mansfield Referral & Diagnostic Process Works

  1. Technician checks incoming voltage (120V or 24V) to the igniter circuit.
  2. Microamp signal on the flame sensor is measured to verify flame rectification.
  3. Damaged igniter or thermocouple is replaced with an exact-match OEM or universal kit.
  4. Multiple start-stop heating cycles are verified before completion.

Local Cost Factors

Flame sensor service is one of the most affordable furnace repairs ($100–$250), while hot surface igniter replacements typically run $175–$450 depending on the brand. Estimate yours on our cost calculator.

Related Services & Areas Covered

Not sure whether your sensor or igniter failed? Read Dirty Flame Sensor vs. Bad Igniter, or check gas furnace repair and cold air repair in South Boulevards, Lexington, and Mansfield.

Frequently Asked Questions